Pacific Marine & Industrial Logo
Pacific Marine & Industrial®       
Manufacturing & Distribution: Marine, Industrial & Defense
 
Info@PacificMarine.net ◊ EnEspanol@PacificMarine.net      
 
 
How PM&I Can Help Prevent Delays
  
Free Classified Equipment Ads: Global & Comprehensive
   
Purchase ONLINE Select Products Only
  
 

Composite Marine Pump Shaft Bearings

Composite Bearings Fitting Instructions

Composite Pump Bearings
   
Composite Bearing Product and Users Manual
 
Composite Pump Shaft Bearing Machining and Fitting Instruction
 
Composite Bearings Product Images
   

Fitting Methods - Bonding

 

The method of fixture will depend upon the design employed, however the key point to be emphasized is that in addition to traditional mechanical fixing, composite materials can be bonded to both itself and metallic substrates. Also of note is that if the assembly is to exceed 60-70°C in temperature then interference fitting should be replaced with adhesive fitting.

 

Numerous adhesives are compatible and have been tested within our laboratory facilities.

Generally the most suitable adhesives are: 

* Epoxies

* Acrylics

* Cyanoacrylates

* Polyurethanes

 

Fitting Methods - Press Fit

 

Fitting with Hydraulic Press or Centre Pull Jacks

 

If a bearing is to be press fitted, installers should ensure that they have equipment available to deliver adequate force to press the bearing fully into the housing. The ease of fitting will vary dependent on the finish of the housing and this should be considered when calculating the force required. When press fitting a bearing it is important that it is in line and square with the bore before the operation beings, an adequate chamfer on the housing will prevent shaving of the bush.

 

Fitting Methods - Freeze Fit

 

Freeze fitting using liquid nitrogen is a fast and efficient assembly method for a composite bearing. The thermal properties of the material allow a good clearance between the bearing and housing when frozen and the material does not become brittle at cryogenic temperatures.

 

Freeze fitting using dry ice and alcohol will only provide the required clearance when using very light interferences. As such it is rarely a viable method in its own right and will often require press fitting as well.

   

Home ] Up ] Composite Pump Shaft Bearing Data Sheet ] Composite Hydro Pump Shaft Bearings Material Data Sheet ] Composite Industrial Pump Shaft Bearings Material Data Sheet ] Composite Pump Bearing Machining Instruction ] [ Composte Pump Bearing Fitting Instruction ] Composte Pump Bearing Product Images ]

   
Join PM&I's Email Newsletter List
 
Free Classified Equipment Ads: Global & Comprehensive
  
California ◊ Florida ◊ Shanghai ◊ Germany
Lagos Nigeria ◊ Valparaiso Chile ◊ Dubai UAE
Trusted Since 1985
 
   
PM&I World Wide Community Service  PM&I Partial Client List
  
Pacific Marine & Industrial is
a registered service mark of:
  
Quality Pacific Manufacturing, Inc.
Copyright 1985-2024
 All Rights Reserved - V3